c6 shift lever help !
- Thread starter Onequick26
- Start date
Help Support Rat Rods Rule:
railroad
Well-known member
I think you have to drop the pan and remove a nut on the inside. You may have to lower the valve body. Not for sure on the valve body.
Option, take a grinder and grind the weld off the attached piece.
good luck,
Option, take a grinder and grind the weld off the attached piece.
good luck,
HOT40ROD
Well-known member
The shaft come out from the inside of the trans. You will need to drop the pan and remove the valve body to do this.
The small shaft with the threads on it is for the kick down level and rides inside the shifter shaft.
If the shifter is design to be used with the original column shift I would just cut off the welded lever. If the shifter is desing for a floor shift lever I would try to use it on the welded piece.
The small shaft with the threads on it is for the kick down level and rides inside the shifter shaft.
If the shifter is design to be used with the original column shift I would just cut off the welded lever. If the shifter is desing for a floor shift lever I would try to use it on the welded piece.
Onequick26
Puts Nitro on his Cheerios
Thanks for the help ! I was thinking I would have to drop the pan.
