Alienbaby17
Well-known member
Hey folks-
Sorry if this has been covered other places- I didn't see it.
I just kind of wanted a confirmationthat I had the gas pressure set right for my welder.
I'm just using a little Lincoln Weld-Pak 10 that I recently converted to MIG after years of just using it as flux-core.
When we set it up for the MIG conversion I couldn't find anywhere that said what the gas pressure should be set at.
We hooked it up and opened the gas valve and the pressure went to about 22psi. I was able to find one place online that said 20-25 psi was good but that was it.
What's everybody else think?
Hat
Sorry if this has been covered other places- I didn't see it.
I just kind of wanted a confirmationthat I had the gas pressure set right for my welder.
I'm just using a little Lincoln Weld-Pak 10 that I recently converted to MIG after years of just using it as flux-core.
When we set it up for the MIG conversion I couldn't find anywhere that said what the gas pressure should be set at.
We hooked it up and opened the gas valve and the pressure went to about 22psi. I was able to find one place online that said 20-25 psi was good but that was it.
What's everybody else think?
Hat