Undead Sleds / Rat Rods Rule - Hot Rods, Rat Rods, Sleepers, Beaters & Bikes... since 2007!

Go Back   Undead Sleds / Rat Rods Rule - Hot Rods, Rat Rods, Sleepers, Beaters & Bikes... since 2007! > Sam_Fear

Conversation Between Sam_Fear and ANNAMEL
Showing Visitor Messages 1 to 4 of 4
  1. Sam_Fear
    12-28-2019 05:45 PM
    Sam_Fear
    Man, I dunno. I'd say split and widen the front fenders like the back, but that is a whole lotta work. Dare I suggest narrower tires up front? A few other thoughts are only putting flares on the back 1/2 of the opening more like a mudflap. Use a mesh instead of sheet metal. Or using tread from a bias ply. I kinda think if you use sheet steel for a flare, it's going to mess up the lines.
  2. ANNAMEL
    12-16-2019 07:27 PM
    ANNAMEL
    Thanks, Its good to be all in one piece. Hope you are doing well. I am getting an english wheel and not sure on the body panell met thickness. Going to make some filler pieces and fender flares to cover the outside edge of my tires. Any idea?
  3. Sam_Fear
    08-01-2019 08:31 PM
    Sam_Fear
    HEY! Good to see you back. Still tryin to get my house in order so not enough shop time besides maintenance, but I've been getting itchy to say screw it and fire up the welder. I do check in daily even if it's just in the BS section.
  4. ANNAMEL
    07-31-2019 06:37 PM
    ANNAMEL
    whats happening, How you been.

All times are GMT -5. The time now is 06:59 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Rat Rods Rule Inc.