HD trike

Rat Rods Rule

Help Support Rat Rods Rule:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I agree with you the radius on the front fender is way off. Your metalworking skills are superb to say the least.[cl[cl[P[P[P
 
Been a while since an update on the trike. Haven`t done too much on it , the owner needs time to save up... :rolleyes::D Made some progress with the centre section. Next up is the floor with room for the mufflers [S on both sides. exhaust tips will exit through the valance. Then on to the deck lid... deck little in this case :rolleyes:
 

Attachments

  • IMGP0905.jpg
    IMGP0905.jpg
    84.3 KB · Views: 55
  • IMGP0906.jpg
    IMGP0906.jpg
    108.4 KB · Views: 58
  • IMGP0909.jpg
    IMGP0909.jpg
    73.7 KB · Views: 50
good grief... slow progress :p oh well, it`s progress

fender needs some fine tuning, a wire edge and planishing...
 

Attachments

  • IMGP1353.jpg
    IMGP1353.jpg
    82.5 KB · Views: 46
Thanks gents. I must say I`m not a bike-guy and sure as heck no trike-guy, but since I designed this body, it should become the best looking trike Ive ever seen ... :p
 
got started on the other fender. Gotta love gas welding :cool:
Single pass not planished yet...
 

Attachments

  • IMGP1543.jpg
    IMGP1543.jpg
    49.6 KB · Views: 85
  • IMGP1545.jpg
    IMGP1545.jpg
    38.8 KB · Views: 35
  • IMGP1548.jpg
    IMGP1548.jpg
    46.5 KB · Views: 32
Are we talking about gas welding as with ox/acc [S
I am a bike guy and that thing is going to be outstanding [cl
Just needs a little rust maybe [S
 

Latest posts

Back
Top