New welding table

Rat Rods Rule

Help Support Rat Rods Rule:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

kenny c

Well-known member
Joined
Jan 4, 2012
Messages
4,184
Location
West Greenwich R.I.
This is a welding table I built from a roll around table I found at the scrap yard and and a bunch of channel iron and threaded rod. The cross members can be moved and clamped along the length of it. the uprights can be slid in and out on the cross members and the angle iron clips move up and down the up rights. I hope this makes sense.
 

Attachments

  • DSC01262.JPG
    DSC01262.JPG
    144.6 KB · Views: 41
  • DSC01263.JPG
    DSC01263.JPG
    143.5 KB · Views: 39
  • DSC01264.JPG
    DSC01264.JPG
    141.2 KB · Views: 37
  • DSC01265.JPG
    DSC01265.JPG
    142.5 KB · Views: 35
  • DSC01266.JPG
    DSC01266.JPG
    134.2 KB · Views: 32
  • DSC01267.JPG
    DSC01267.JPG
    145.4 KB · Views: 31
  • DSC01268.JPG
    DSC01268.JPG
    141.4 KB · Views: 31
  • DSC01269.JPG
    DSC01269.JPG
    139.9 KB · Views: 35
  • DSC01270.JPG
    DSC01270.JPG
    137.1 KB · Views: 36
  • DSC01271.JPG
    DSC01271.JPG
    143.3 KB · Views: 44
Looks like a world class frame table. You know, everything you build on it has to be spot on now.:D
 
Nice job on the table Kenny!

I picked up some sorta pallets that are about 5' x 5' or so and made out of 2x2 square tubing that I'm gona use to build one. I'm not anywhere ready for that yet though.
 

Latest posts

Back
Top