View Single Post
Old 09-01-2019, 05:48 PM
BigR BigR is offline
Junior Member
Join Date: Aug 2007
Location: Prescott, AZ
Posts: 15

Finished bending and cutting the rear bumper. I had to add more curve outbioard to match the fenders. This time I weighted down the press with a motorcycle jack, concrete filled coffee can and a bench vise.

Cut 5 inches off each end. Rounded off and polished one end then just had to put it on the car and take pics. Looks pretty good, if I do say so myself.
Attached Images
File Type: jpg rear finished.jpg (16.3 KB, 12 views)
File Type: jpg reverse bend 1.jpg (17.5 KB, 12 views)
File Type: jpg left finished.jpg (15.4 KB, 11 views)
John in Prescott, Arizona
Reply With Quote