Heres a quick little tool. I was pulling this rear apart to get the drive shaft out for a set of original style lakester headers. drove the pin out but the pinion shaft didnt want to give up the connentor. so to the the shop and found a piece of 3/8 plate drilled a 1 1/2 hole then took a grinder with a cut-off wheel to open to the side. Then two 1/2 inch holes 1 7/8 from center.
2 pieces of 1/2 inch rod and some nuts. I used some of my hold down pieces from my mill but I think you'll get the drift. Hope this helps out.
2 pieces of 1/2 inch rod and some nuts. I used some of my hold down pieces from my mill but I think you'll get the drift. Hope this helps out.
