Thanks a lot for that info . My plexi glass windshield will be replaced be fore I use it again .After getting my glass windsheild broke last week, there's no way I would ever run a plexi windsheild in anything again. That lick was so hard it would have went straight through a piece of plexi. Could have been bad if it had of been on my side. The safety glass did it's job, even though I still got some glass splinters inside, the glass stayed intact in the frame. I would have been wearing a piece of plexi!
After getting my glass windsheild broke last week, there's no way I would ever run a plexi windsheild in anything again. That lick was so hard it would have went straight through a piece of plexi. Could have been bad if it had of been on my side. The safety glass did it's job, even though I still got some glass splinters inside, the glass stayed intact in the frame. I would have been wearing a piece of plexi!
Glad to see ya installing a glass windshield!!!!!!!!!!!!!!!!!!!!!!
I put a lexan windshield in my 40 and it blew in and damn near took my shoulder off. Only glass for me!!!
After getting my glass windsheild broke last week, there's no way I would ever run a plexi windsheild in anything again. That lick was so hard it would have went straight through a piece of plexi. Could have been bad if it had of been on my side. The safety glass did it's job, even though I still got some glass splinters inside, the glass stayed intact in the frame. I would have been wearing a piece of plexi!
Glad you are replacing yours tripper.[cl [cl
Torchie
I feel your pain... my windshield took 3 tries to get something that would go in...
I've learned a lot about making proper templates however... a plexiglass template is your friend because its rigid enough for test fit, and they make it identical to your template that way.
Looking good Bob.
When I chopped my cab I was real particular about getting the pinch weld all on the same plane.Makes installing the glass so much easier.
Torchie
Enter your email address to join: