![]() |
|
Businesses, Vendors etc! A section for business & kool kats to tout their shops, services & products! Whatcha got!? |
![]() |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
![]() It does not mater if it is you daily driver ,rat rod ,Street rod, or Bus I have a 3000 sq foot shop behind my house here at 5025 Sherwood Dr. Fort Worth Texas 76114 I am a ASE certified master Auto, Truck, & Bus tech Cadillac Master Tech last 2 years at the dealership (10 years at Frank Kent Cadillac) I do all work from brakes to complete chassis builds, motors and wiring and everything in between have had customer cars in major magazines (these were ground up builds) I am currently charging $30. an hr straight time and am fair with the hours. I am now retired at 50, and not trying to make a killing .I have very little overhead and love working on the old cars I will even let you watch and help I you want to learn if you need a lug nut replaced or a car built or any thing in-between I can help I prefer to use your parts but will furnish parts at 10% mark up if needed Dan Dagel 817-626-1418 leave a message I will call back dageldan@aol.com
__________________
![]() |
#2
|
||||
|
||||
![]()
The 67 got a 502 big block, 4 sp, and the factory ac reworked
Dash was pulled a fully restores chassis got rebuilt disc add up frount cleaned and undercoated Ps got rebuilt frame and fire wall were sand blasted and painted
__________________
![]() |
#3
|
|||
|
|||
![]()
If your good with bus repair you might check out bus conversion magazine forum. It's for converted tour busses. They have a section for repair facility's that can offer service work when on the road. It's a brotherhood over there. If one guy likes you, they all like you and will use your services.
|
#4
|
||||
|
||||
![]()
good with buses but the 1 car garage I have to go through only has a 7' tall door so I do very little work on large vehicles
__________________
![]() |
#5
|
||||
|
||||
![]()
I have been lurking around for a while and not posting so thought I would take a few minute share what in the shop getting knocked out 1st is a 50 Buick convertible got 500 EFI Cadillac engine next 2 are 53 ford and the my 59 5,0 EFI
been staying busy There is a 29 model a 2dr sdn coming up been gathering parts so far I know it will have a 331 hemi with auto overdrive 4"drop axle with 45 fin Buick drums got just about everything but the quick-change rear it will be a cross between a rat rod and a traditional rod .The new wood kit will get stained and inside done in Red Oxide colored BC, Chicken wire roof and 2 seats outside will be left as is The 29 is out of Wissicon and has solid metal and no cancer well time to get back after it have a happy Halloween
__________________
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|