acourtjester
Well-known member
HI
Here is something I have used many time that may help others.
When making up the wiring on my Rods I use word to make the names for the wires. And before attaching the end connecters I cut the names info small strips and wrap them around the wire and cover them with heat shrink tubing.
this gives you a lable on the ends where they are connected. If you disconnect them it helps when you reconnect them. Also when using a terminal strip I put a lable for each wire next to the strip and seal it with clear nail polish. This is shown in the second picture under the wires.
The picture shows my air bag control switches.
Have fun
tom
Here is something I have used many time that may help others.
When making up the wiring on my Rods I use word to make the names for the wires. And before attaching the end connecters I cut the names info small strips and wrap them around the wire and cover them with heat shrink tubing.
this gives you a lable on the ends where they are connected. If you disconnect them it helps when you reconnect them. Also when using a terminal strip I put a lable for each wire next to the strip and seal it with clear nail polish. This is shown in the second picture under the wires.
The picture shows my air bag control switches.
Have fun
tom