banditsbadrides
Member
I have a 95 Dakota frame, with the 6 lug wheels, but I want GM 4 3/4" bolt pattern. Anyone know what rotor may be a direct fit??? I can change out the rear to a GM fairly easy I think.
What Rotor will work ??
- Thread starter banditsbadrides
- Start date
Help Support Rat Rods Rule:
Shea Laking
Well-known member
You're going to have to do some cross-referencing with regards to inner and outer bearing sleeve and race measurements, as well as overall rotor diameter, thickness and center hub (where the studs go) height. It would have to be a mix and match of different manufacturer's pieces to make this work.
I had started looking into this cross-referencing when the whole "AD-on-Dakota" phenomenon took off, however I never stuck with it to finish up, so sorry, I don't have concrete results.
You could always purchase earlier 5-lug rotors ('87-'90 Dakota). These are the Dodge/Ford 5x4 1/2" bolt circle, though. Also be sure to get rotors for a 15" equipped truck. Ones that originally had 14's had a smaller diameter rotor.
Sorry I couldn't offer a concrete answer to your original question....
Regards,
Shea
I had started looking into this cross-referencing when the whole "AD-on-Dakota" phenomenon took off, however I never stuck with it to finish up, so sorry, I don't have concrete results.
You could always purchase earlier 5-lug rotors ('87-'90 Dakota). These are the Dodge/Ford 5x4 1/2" bolt circle, though. Also be sure to get rotors for a 15" equipped truck. Ones that originally had 14's had a smaller diameter rotor.
Sorry I couldn't offer a concrete answer to your original question....
Regards,
Shea
