I see a lot of you do structural framing

Rat Rods Rule

Help Support Rat Rods Rule:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

choppinczech

Well-known member
Joined
Oct 16, 2012
Messages
423
Location
Santa Clara, CA

Attachments

  • 1 inch tubes.jpg
    1 inch tubes.jpg
    8.9 KB · Views: 32
I think you should buy twenty of them
And then make..
Well,
I guess make something round........
 
on the insides of your car bodies. These would save me a lot of time since I don't have a tubing bender.

Shipping is a flat rate cost for 1 or 20.

http://www.ebay.com/itm/180514104066?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649#shpCntId

I wish I would have seen these before! I just finished a framework for my track nose and I had to piecut the tubing like an accordion then weld in a strengthening plate. In the near future I'll be fabbing a body structure for my roadster. I'll be ordering up a few of these from you. Is it thick or thin walled tubing?



 
Great Job Turbo.

Just before Firing Order Magazine , closed down, I had sent in my tech page, and I had a whole page on how to make those cool bends in all different radiuses.


There was a lot more to it, but you get the idea.

Bruno, 14 gauge tubing, is .083 Not sure why they didn't just say that.
 

Latest posts

Back
Top