BillM
Well-known member
Does anyone out there have any creative ideas for filling and/or sealing the hood lace holes in the cowl on my car?
Obviously, you've already determined that I'm not running a hood! I like the look of them, but I need to seal them to prevent water from getting in. Short of removing the "tang" from the U shape and welding them closed, I was hoping someone on here might have an idea for a better way. I kind of like the look of them, so I hate to cover them up. I'm considering welding little "blanks" on the inside of the cowl, sealing them with seam sealer and give the outside a good coat of POR.
Any ideas?
Obviously, you've already determined that I'm not running a hood! I like the look of them, but I need to seal them to prevent water from getting in. Short of removing the "tang" from the U shape and welding them closed, I was hoping someone on here might have an idea for a better way. I kind of like the look of them, so I hate to cover them up. I'm considering welding little "blanks" on the inside of the cowl, sealing them with seam sealer and give the outside a good coat of POR.
Any ideas?