Wow at least mine was clear on what was hitting LOL. So I got my master cylinder and booster. I knew it was going to be tight with these valve cover spacers I had to put on. Well it's really close, it actually doesn't fit the way it should. I ended up having to trim about a half inch out of the fire wall mount and then I had to build spacers for the inside of the mount to kick it off at an angle a little bit. It's not a hundred percent bolt it down so once I get that done it will pull it away from the valve cover a little more. I'm going to do a little more clearancing just to make sure it doesn't hit. I was going to try and use a 45-degree mount like the early Broncos use when they put power bites on them but I do not have enough room. It would hit the inner Fender whenever I get that fixed and put back in