T2T
Still running with scissors!
Before I made my blocks I made a set from wood. This way I could move it outside and stand back and look........................
I had some one inch aluminum I cut using a band saw, a table saw with a carbide(wood) blade will work too. Next drill a 1/2" locating hole in the center. I made the locating pin out of half inch stock, one inch long.
I wasn't sure if one inch was gonna be low so I also made a 1/2" block to add to the 1" one.
I had some one inch aluminum I cut using a band saw, a table saw with a carbide(wood) blade will work too. Next drill a 1/2" locating hole in the center. I made the locating pin out of half inch stock, one inch long.
I wasn't sure if one inch was gonna be low so I also made a 1/2" block to add to the 1" one.
Last edited: