I have seen a couple of articles on other forums about using these clamps for aligning and welding sheet metal, see the photo below. There was even an article on making your own.
I personally need to spend my time building my car (I work over seas, not enough time at home...) so I bought the clamps.
I found some on eBay, $1.50 each if any one is looking for these.
Item number is 150120776700 and the guy has a few hundred to sell.
Just copy the number and past it in the search window.
I got 10 of them and with priority shipping it was under $24.00.
Just thought this might be of interest to some of you. '22
I personally need to spend my time building my car (I work over seas, not enough time at home...) so I bought the clamps.
I found some on eBay, $1.50 each if any one is looking for these.
Item number is 150120776700 and the guy has a few hundred to sell.
Just copy the number and past it in the search window.
I got 10 of them and with priority shipping it was under $24.00.
Just thought this might be of interest to some of you. '22
Attachments
Last edited: