That looks great!
Just curious, are the top and bottom wheel parallel or at a slight angle? An old feller told me once that they are much easier to work with when the bottom wheel is off by 2-3°.
not sure what that`s based on... when using full radius anvils, it wouldn`t make much difference, but with flat centre wheels all you would create is tracks...
We just built the stand that holds the tooling heads etc. Our customer bought the stuff at Hoosier Profiles http://hoosierprofiles.com Then brought it to us with a print of what the stand was to be built as.
There is plenty of adjustment in the tooling head so you could get that couple of degrees your talking about.
looks good, but you will be very limited on the amount of crown you will be able to work with, with the throat that shallow
Well, well, well. Look what the cat dragged in
Good to see you around again Mike.
nice start! [cl
Enter your email address to join: