Rear axle Ford F1 '52

Rat Rods Rule

Help Support Rat Rods Rule:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Kikerman

Member
Joined
Jan 20, 2014
Messages
14
Location
Puerto Rico
Hi! I need a help for my proyect! I'm working on '52 Ford F1 I'm going to use a 350 corvette engine with 350 trans, can i use the original rear axle? What axle did you recommend to use? Im gonna use C-Notch to cut the frame and lower it down! Thanks for your help!
 
If I remember right, there are not any setups to make that rear end a posi setup, and I think they were 4.27:1 ? Should be a Dana 41 I believe.

Pre 1973 F-150 has the ford 9" that apparently is almost a bolt in swap.
And 57-67 F100 9" rear end is a direct bolt in.
 

Latest posts

Back
Top