Recent content by phillip-r-s

Bubble tops i think it is amazing that they can do it, frankly if everyone can see my big goofy grin they are going to know i'm up to no good, i like a car i can hide in.

It worked pretty slick, straightened the curved tire out really well. When i got ready to bolt it down i put two pieces of angle on top, and clamped it in the press to push/ hold down the edges.

Uses for tractor tire Uses for tractor tire Lower piece is made, tried it out, works good Also did a press with the tongue depressor shape just by stacking everything, so next is making and weld a mount onto the 1inch bar stock

I’m not real proud of the welds, but everything has been tri- welded with 7018 rods, leaving good penetration; just not pretty. Did a couple test bends, very happy so far. Next I will start making the bottom plate, I think I have everything I need, and a general idea of what I’m doing.

Congrats, keep us informed, cant wait to see what rolls in and out of it.

Ithe first part is a sheet metal brake and then i want to be able to mount different types of forms to the brake The first form im wanting to make is just a tounge depresser shape for a set of replacement step panels for 57 chevypickup

so far...... Step One of Three First I wanted to make the upper mounting bracket / sheet metal brake. Here is a pic. of it all cut out and ready to weld. Going to weld it this weekend and start the bottom mount that will hold the section of rubber from the front tractor tire. p.s. I cut the...

thank you Thats it thank you

i just opened it again without prob. I tried to cut and paste it all but that didn't work, will try when I get to a computer.

i think i have one And will look as soon as the rain snow and sleet pass

i am wanting to try this http://www.answers.com/topic/sheet-metal-forming#page2

I am wanting to find some to use in a shop press for metal forming but everything i have found seems way over priced... thinking about trying the rubber patio pavers from home improvement store any thaughts

Woops that was a month ago hope he got it goin

If your are getting spark, it sounds like timing to me but her is a diagram for ya. http://farmall140.com/wp-content/uploads/2012/10/Farmall-6-volt-Positive-Ground-Wiring-Diagram1.jpg

You said your getting spark, in that case it sounds like your timing is off.