Search results

One problem you have fitting a transmission tunnel tight to the transmission to save room in the car is the dip stick. Here is a solution. Start by measuring your dip stick and tube. Cut about 2 1/2 inches off the tube at each end. make 2 fittings that fit your tube ends and go down to 3/8...

Start by measuring the location of the 1/4 inch pipe fitting outlet in the bottom of the tank. Locate the fuel sender directly above it. Drill a hole in the top of the tank the size of the hole in the gasket. Locate the sender the way you want it to face so it does not hit the side of the...

On some of your highly channeled cars with large tunnels here is some pics of how to cut seats down to fit the car without messing up the upolstry. We took 3 inches out of these seats by removing the upolstry and cutting the metal frame 3 inches out of the center, then welding it back together...

My husband and I own a small welding shop in St. Paul, MN ...been there 30 years. We do hot rods to kitchen chair repairs, whatever pays the bills, and in Minnesota the heat bills are high, so even that 747 plane we'll do if you take the wings off :). The reason we are 'tator is we built a...