Search results

I'm trying to get brake pressure into an under floor brake system. I am using residual valves in the proper way disc fronts, drum rear. WE have gone blind bleeding the brakes. Not sure if the master is proper? there are about 10% brakes... :mad:

I have seen rat rods with a semi exposed transmission case above the floor, with no tunnel. So my question is how hot does the transmission case get? Thank you, and be well

Hello, I need the wiring schematic for a 1998 cadillac deville tail light. Thank you.

So I have too few water sensor outlets on my manifold. Thermostat housing is not an option. Can I use one port with a "T" fitting to house both the temperature sensor and the fan sensor. Thanks

So I have 1934 Ford truck headlights. They house the bayonet mount light incandescent bulbs. Are there bayonet halogen replacement bulbs, or do I need to get new sockets as well? Let me know the set you have used. Thanks, Tom.

So my question is, when the bolt runs through the steel protection sleeve, Is the steel sleeve to be pinched between the bracket it rotates on? In other word does the bushing and steel sleeve rotate together or does the steel sleeve stay stationery while the rubber rotates around the sleeve? So...

Here is where i'm at. Both doors are a 3/16 low at the b pillar. Shimming may not be an option because I'm channeling the body. with the hinge pin in the center hinge, I can pivot the door to the proper position. The lower hinge needs a minimal pinch in, but the top hinge needs to be moved back...

So I was testing my auto dark welding helmet with a powerful led work light. To my surprise it does not tiger the darkening sensor. So if you have old eyes like mine, and you need to illuminate the area you are welding, led light is the way to go! Cheers

So I have a original gas tank on my 29 Model A, which I want to keep in place. I would like to neutralize the fumes without contaminating the tank. I have seen that steam might be the way to go? Your thoughts, Thanks

So I'm keeping the original gas tank (functional) I want to hang a custom dash over the existing dash with enough space to put in modern gauges. Are there any prefab customs or alternatives? Thanks, Tom

So I'm well under way with my slammed model A sedan project. I'm going to use a mustang II front end. The the car will be void of hood, fenders and running boards. The engine is a 454 with 700R4. Not sure on front wheel/tire diameter at this point. The question is power rack or standard steering????

I have been needing a heat source for breaking rusted nuts from bolts. Propane has been ineffective, to cold. Acetylene is the obvious choice, but is there a single tank set up for this application? Thanks for any suggestions.:confused:

So I'm running a 454 with a Big Cam therefore low vacuum. Here is the deal, I might go with a non-power steering set up, but want to capture the vacuum for the brakes. Not sure how to set up the system bypassing the power steering component? Any thoughts would be appreciated. Thanks.

I want to use a good dealer who sells Cloth Braided Spark Plug Wires. Modern engine build ( new style boots) ,but I want to dress it up with vintage look. Who would you recommend.

Building a 454 big block, pre -1980 not sure about what spark plug to use for good performance, , washer style. Thanks, Tom.

I am building a Model A Tudor Sedan. Which S10 wheel base works best? I am using the Main cab only. In other words, DELETE fenders running boards and hood. Thank you for your help! Tom.