Undead Sleds / Rat Rods Rule - Hot Rods, Rat Rods, Sleepers, Beaters & Bikes... since 2007!

Undead Sleds / Rat Rods Rule - Hot Rods, Rat Rods, Sleepers, Beaters & Bikes... since 2007! (http://ratrodsrule.com/forum/index.php)
-   Builds! (http://ratrodsrule.com/forum/forumdisplay.php?f=21)
-   -   My 40 Dodge Truck Build - Maybe a 41 LOL (http://ratrodsrule.com/forum/showthread.php?t=38515)

Couper 09-07-2020 08:32 PM

My 40 Dodge Truck Build - Maybe a 41 LOL
 
3 Attachment(s)
This what she looked like when I bought her

Couper 09-07-2020 08:38 PM

5 Attachment(s)
I wish I knew what I was buying,,,,geeze ton's of rot but wasn't turning back

Couper 09-07-2020 08:42 PM

5 Attachment(s)
Some chop pictures.....before & afters

Couper 09-07-2020 08:50 PM

5 Attachment(s)
New Sill & Rocker Panel. Area of Floor at rear of cab to tie in sill. Piece of 1.5" Angle to tie in the front of the sill

Couper 09-07-2020 08:59 PM

5 Attachment(s)
Body Work on roof, passenger side and rear panel is close enough for a high build primer.

Torchie 09-07-2020 09:14 PM

Chop looks great.
😎😎😎😎😎😎😎
Torchie

Couper 09-07-2020 09:17 PM

3 Attachment(s)
This is the condensed version.... There has been a lot of other stuff that almost had me throw in the towel. Like when I pulled the "T" trim out of the roof joint and found the joint so rotted that I had to seal weld the complete joint. Or like after I chopped and fitted the door passenger side door that looked awesome outside but was a wreck with wide ass gaps on the inside. I had to "clad" the jam to make it look right......

Couper 09-07-2020 09:27 PM

5 Attachment(s)
Then we have a complete rebuild of the passenger door you see there

Couper 09-07-2020 09:29 PM

1 Attachment(s)
And the outside of the door

Couper 09-07-2020 09:42 PM

So there ya have it....that's where I am at the moment. I'm waiting for a driver side door to show up and then I can finish the left side and get the whole cab in high build. I have to do the driverside sill and the complete floor. Have to decide on a drive train (I's like a Hemi or Nailhead), front end (transverse leaf spring) rear end (no idea) so I can do a mock up and start building a frame.

I'd love to hear from some of you guys on rear frame kick up, front z or stack,
which front end would be best.....ect.

Thanks for looking and thanks for any ideas you might have for me.

Very interested in hearing from Bruno....

Couper


All times are GMT -5. The time now is 07:06 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
Rat Rods Rule Inc.