Recent content by RPM

Get well soon there Don

The middle seat from a Dodge Mini Van works pretty well.

The Caddy has the BPO bolt pattern. I have the 200 4 r behind my 500 Caddy. Lower first gear and has OD. These can be beefed up they were in the Buick GN

We build custom tube axles. http://www.eztbucket.com/Dropped-Tube-Front-Axle-5020.htm

I think a lot of the traffic is going to Facebook, so many different groups on there.

I still have that pattern for that front end, from way back when we made them, for WTS

Why does DOM come in random lengths instead of standard lengths like other materials?

We have 3 Hypertherms in the shop. Consumables and support are important things to look at. You cannot have any moisture in the air lines.

I make and sell a lot of parts to West Texas Speed, good people.

$1.58 for regular

I used to watch it quite a bit, but lost intrest in it, a couple of years ago. Does anyone watch Shark Tank? It is pretty interesting, and always different.

I have a 600 and we just out grew it as far productivity was concerned. It will only cut 3/8 at 15" per minute. Then it would overheat in about 25 minutes of continued use. We bought the new Hypertherm 85 and it is a real work horse for us. It cuts the 3/8 at 75" per minute and runs nonstop...

Could the magic number be 69 ?

25 degrees this morning, too dang cold for my liking.

I sell bucket bodies for just $399, and shipping is usually less than $150.00. Yea they are glass. You paint it to look like rust.