Reply to thread

Put together some bracing for the seat back.

And test fitment.

And start on more bracing to apply interior panels to.

First panel in place. I'd do it all in one piece if it wasn't so hard to work with such a large piece but in my case, and limited tools this will be fine.

And cardboard cut out for the rear corner. The curves are a bit tricky to duplicate so it's a lot of banging after I get the panel into place.

And in this one you can see a few of the different panels I had cutout and molded into shape. My favorite metal shaping tool by the way, a dead blow hammer.

Panel below the window

And without the seat bottom in place.