Detroit locker, what do you think about this?

[maddog]

I found this on Ebay. It would go right into my rear end.

http://cgi.ebay.com/ebaymotors/ws/e...DME:B:DBS:US:1123&viewitem=&item=180175480920

What are your thoughts?

Thanks.

 

[Bonehead]

Since we didn't talk you out of it.......

Did you notice it says H case locker? I am not sure about the case, usually it is the bearings at the end of the axle that divide up the 9 inch. Check that if you can. Price seems good.

 

[Gastrick]

I though you had decided against the locker

Well a new one would cost you over 500 bucks without the gear set or bearings. But............the one on ebay was used in a racecar and could be beat to death so it's a crap shoot but the price seems fair so far.

 

[Gastrick]

"CASE SIZES......H-case lockers will fit a case with a 3.250" bearing seat. B-case lockers will fit a case with a 2.891" bearing seat. B-case is factory standard. To use an H-case locker you need an after market case with a 3.250" bearing seat."

 

[maddog]

Ok, ok, now I've been talked out of it.

I had been watching this item and it just poped up in my email.

Thanks guys.

 

[joehalford01]

I found this on Ebay. It would go right into my rear end.

oh really.......