Drop spindles?

[martyf]

Do they make a Drop spindle for Stright axle?

yeh Im using a drop axle (4") but what IF I want to go lower with out getting into cross steer linkage problems, figures a drop axle might work

woot say ye?

 

[Dirtyrat]

Check out speedwaymotors.com

 

[Gastrick]

woot say ye?

I say "Z" the chassis if you want to go any lower than that with a beam axle. Just my opinion.

 

[donsrods]

I don't know of anyone who makes dropped spindles for an early Ford axle. Years ago I saw an article on how to take AMC bolt on spindles and make a steel plate that bolted between the original Ford spindle (with the part that sticks out cut off flush) and the AMC spindles. It was a way to get the front end lower without a dropped axle.

My suggestion is to do what Gastrick mentioned .

Don

 

[RPM]

What about using a dropped perch? We make dropped perches up to 7" tall.

 

[martyf]

I have searched for a while I havent found any but I thought I would ask

Im already going to Z the front and 4 and Ill be adding the drop axle of 4 so that give me 8 (the rear will be 12) so Im thinking this will be close to what I want, but after its all done, if I wanted lower I was thinking a spindle.

oh well

I need to look into that perch