Frame questions

[Boltbreaker]

I have a question about my frame. I am changing the rear of my frame because the kick up was too high and the length was incorrect since I changed my bed design.
If I angle the two upper horizontal rails (that will be welded to the kick up rails) OUTWARD will it screw anything up with the mechanics of the suspension?

I still have to cut and fab the crossmembers to mount the coils and pan hard bar to, but need advise about the upper rails first.
Thanks,
BB

 

[Bonehead]

Short answer is no. Many factory frames angle in and out as they go along. The only thing I can think of is it may make all the bracketry a little harder to fab.

 

[Tripper]

I still have to cut and fab the crossmembers to mount the coils and pan hard bar to, but need advise about the upper rails first.

Breaker,
Just make sure u're dragger's not bumpin'!!!

BoB

 

[Boltbreaker]

Breaker,
Just make sure u're dragger's not bumpin'!!!

BoB

I'm a total idiot I guess, but that went right over my head

 

[Tripper]

I'm a total idiot I guess, but that went right over my head

Breaker,
Sorry... it's an *old* rodders' joke! Make sure u're bumper's not draggin'!!!

BoB

 

[Boltbreaker]

Breaker,
Sorry... it's an *old* rodders' joke! Make sure u're bumper's not draggin'!!!

BoB

How embarracing....how did I miss that one.

 

[Oldrodder43]

Don't feel bad kiddo, went over me too, but then I ain't the brightest bulb in the socket! Lots of things on here stump me. Perley