mikec4193
Well-known member
Hi Rat Rodders
I have become very close friends with my tape measure...and my grinder and my welders too...
First time with the tape and welders
Still didn't look right....more chin scratching
nothing was lining up again...
I finally had to to give up on it all...I made a post on a 6 cylinder Chevy Facebook group and asked what were my options to get this motor to sit in there in a correct way....
Hortons hot rods out of Canada somewhere hooked me up with motor mounts...
In all honesty....I don't think I should be building these things but I need something to do at night...
So for this part...3 times for both the motor and the tranny mounts...
So how many times do you cut and chop and weld before you can sit back and say..."I think I got it"...???
MikeC
I have become very close friends with my tape measure...and my grinder and my welders too...

First time with the tape and welders

Still didn't look right....more chin scratching

nothing was lining up again...
I finally had to to give up on it all...I made a post on a 6 cylinder Chevy Facebook group and asked what were my options to get this motor to sit in there in a correct way....

Hortons hot rods out of Canada somewhere hooked me up with motor mounts...
In all honesty....I don't think I should be building these things but I need something to do at night...
So for this part...3 times for both the motor and the tranny mounts...
So how many times do you cut and chop and weld before you can sit back and say..."I think I got it"...???
MikeC