I see a lot of you do structural framing

[choppinczech]

on the insides of your car bodies. These would save me a lot of time since I don't have a tubing bender.

Shipping is a flat rate cost for 1 or 20.

http://www.ebay.com/itm/180514104066?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649#shpCntId

 

[Old Iron]

So, what is your question?

 

[billy]

I think you should buy twenty of them
And then make..
Well,
I guess make something round........

 

[earthman]

Good stuff. Lot of uses.

 

[2.3Turbo_T]

on the insides of your car bodies. These would save me a lot of time since I don't have a tubing bender.

Shipping is a flat rate cost for 1 or 20.

http://www.ebay.com/itm/180514104066?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649#shpCntId

I wish I would have seen these before! I just finished a framework for my track nose and I had to piecut the tubing like an accordion then weld in a strengthening plate. In the near future I'll be fabbing a body structure for my roadster. I'll be ordering up a few of these from you. Is it thick or thin walled tubing?

 

[bruno]

It,s .083, 13ga?

 

[Bonehead]

Great Job Turbo.

Just before Firing Order Magazine , closed down, I had sent in my tech page, and I had a whole page on how to make those cool bends in all different radiuses.


There was a lot more to it, but you get the idea.

Bruno, 14 gauge tubing, is .083 Not sure why they didn't just say that.

 

[choppinczech]

Not mine, or anyone I know. Just ran across them and thought they could be handy.