street rodder mag

[earthman]

Just looking at the new St Rodder on the rack at the store this morning.
They are building a '51 Chevy and leaving the surface rust body "as found". They are wildmen i tell 'ya! They said of course the '57 235 six that was in it would be replaced with a 350/350. I'm sure they don't want to upset the conservative readership with too much deviation from the formula.They are trying to keep the cost below $15,000.

 

[2muchtorque]

My favorite part of that mag..................... is the 20% off at Harbor Frieght coupons

 

[earthman]

My favorite part of that mag..................... is the 20% off at Harbor Frieght coupons

[cl

 

[hotrod preacher]

i'd be biting my nails to see if they can actually pull that off for such a tight budget........a cliff-hanger fer sure


but they sure are thinking "outside the box" with that wacky old rusty paint[cl

 

[the reverend muddy grimes]

hey, it beats the fake Patina the guys on trucks did on their project

 

[earthman]

i'd be biting my nails to see if they can actually pull that off for such a tight budget........a cliff-hanger fer sure


but they sure are thinking "outside the box" with that wacky old rusty paint[cl

Come to think of it the must not be any paint suppliers advertising in the mag right now.

 

[rustybeercan]

They are trying to keep the cost below $15,000.

i'd be biting my nails to see if they can actually pull that off for such a tight budget........a cliff-hanger fer sure but they sure are thinking "outside the box" with that wacky old rusty paint[cl

hey, it beats the fake Patina the guys on trucks did on their project

Those guys are always on the cutting edge!

Beercan

 

[2muchtorque]

My favorite part of that mag..................... is the 20% off at Harbor Frieght coupons

Just so I am not toooo much of a hypocrite[S, I admit to reading the mag, I dig the articles by Ron Covell in the Metalworking Tips section as I have used some of his practices in a few of the bikes/choppers I built and shown. Shop Manual section by Ron Ceridono, also has some great tech stuff.

 

[Willowbilly3]

Someone gifted me with a subscription for 2 years. There are several laying around I haven't even looked in. Just not my cup of tea. Now if they had got me a subscription to Rod and Custom....