Are you entering anything into the show? I wish i could go.. But way to far right now. I'd love to see that part of the country again. I worked one summer at a boat marina on Lewis Smith lake close to Double springs. Get some pics. if you can.....
Nope. What I did was made the bar my brakes. I pull down on it and it applies my brakes. So when the rod goes down the plunger comes down completeing the curciut. Then your lights come on. I don't have a brake pedal. but for satey, i'm putting a foot pedal in it.
Cut wholes in the back for brake/tail/turn lights. Then make bracket for brake light switch. I wanted it exposed to be different. I couldn't find the nut that goes to the switch,so i used a 1/2" lug nut. Same thread!! Got lots more ideas for the rest of the dash!! I'll post them as i do em. The...
That is going to be a lot of fun cruzin the strip!!! Babes in the tub,, Oh yea i can see it now!!! Lookin good. Can you get a larger photo of the hood release?
Thanx,,,,Skull, do you have a favorite pic. of you truck? and if so is it on a thread? if so where? Or you can post it here,Idon't mind. I would like to show you what i do.
I used an air compresser for fuel tank. It was easy to clean out. I used a 3' piece of throttle cable from a lawn mower. Put one end in a drill, put other end in the tank and turn it on. Move it in and out, working it around. took 20 min. Then i flushed it with gas a few times.
That's one of the ways I was thinkin. Then theres the webs, I thought putting webs in it made of 1/4" rod. So many options. I evn thought of using stainless steel 18 guage, and lazer cut a hillbilly by a stil..but open enough for air.