Search results

I bought a 96 Dakota to subframe my 59 Plymouth. I've never done it before but excited to jump into it. My main question though is do I need to have the v8 setup in the Dakota clip to get the ride height I need. Another question is will v6 shocks from the Dakota effect the ride. Thanks for the help.

Just got my front window gasket and getting the windows made how hard is it to install myself anyone else ever do it on their own any threads or videos. I have 53 dodge pickup. Thanks

I'm looking to replace the front glass and was wondering where to get the front windshield seal weather stripping. I have a 1953 dodge pickup truck.

I stop using the foulers it drives and sounds great I'm not loosing oil. But still want to figure out why the foulers were used. I'm going to do a compression test soon just wondering what should the compression be at and if the compression is good would I just need to change valve seals. Thanks...

OK messed with the idle screws and points and stays running but wants to die when I put it in gear its never ending problems now I hear a rattling from the trans. Any suggestions on why it wants to die when put in gear thanks for the help guys

It has points and was running before the trans swap. It did sit a few months though. I'll check the points later today.

It doesn't look like that now that's the only picture I have on my phone. I'll take more later

Its running the exact same way it did before I rebuilt the carb

It runs smooth till I let off the gas then slowly dies. No vacuum leaks that I can see the idle needles were taken out and put in and backed out two full turns. Pluggs correct. I tried to run it open choke no luck haven't tried it closed.its a Holley doudle pumper and I have Manuel brakes

OK tried the sea foam nothing so I rebuilt the carb nothing. What else could it be not sure how much fuel exact but have pressure but I have. My distributor hasn't moved so my timing should be the same. Anyone else got ideas maybe the choke.

Heck yeah. Glad to here that. Mine ended up being a freakin spark plugg

I hope you figure it out I'm having the same problem with my except my engine is a slant 6. Good luck.

Thanks guy I'll give the seafoam a try before I take apart my carb

I don't have another carb I'll try and clean it. Hopefully that's it

There's no vacuum to the trans I'll check the others

It only runs when I push the gas when I let off it dies. Doesn't idle. When the trans went out it ran fine.

I finally got a transmission for my 440 its been sitting awhile but not long. It starts up fine but won't stay on unless I push on the gas. Won't idle at all could it be fuel pressure. Its been sitting around 2 months could the carb be clogged. Suck I finally got a transmission and run into...

How do I wire my heater fan its beginning to get chilly and looking to hook up my heater box should I use the original 6 volt motor or a 12 volt I have from a Dakota heater box.

I know this question gets asked a lot but does anyone have threads on chopping a 53 dodge truck. I've never done it before. Maybe some opinions on laying the front window back vs splitting the roof. I've seen other 53 dodge trucks chopped but not sure how much to chop. Thanks guys

Thanks guys