pistolpete
Well-known member
Been searching and searching and figured there'd be someone can give some insight.
Is it possible to paint (not high quality by anymeans) and run say an air die grinder on a 120V compressor? I have been looking and from the specs painting is a stretch. As far as a die grinder or a small air saw, I can not really find what cfm and pressure they need... I know there are a million and 30 answers to this question. Just looking for some real worl experience from someone who has done it.
I know I should be looking 220V, but I dont have the floor space, and I only have one 220 outlet in the garage and would prefer not to tie it up with a compressor all the time... Any opinion/comments would be greatly appreciated.
Is it possible to paint (not high quality by anymeans) and run say an air die grinder on a 120V compressor? I have been looking and from the specs painting is a stretch. As far as a die grinder or a small air saw, I can not really find what cfm and pressure they need... I know there are a million and 30 answers to this question. Just looking for some real worl experience from someone who has done it.
I know I should be looking 220V, but I dont have the floor space, and I only have one 220 outlet in the garage and would prefer not to tie it up with a compressor all the time... Any opinion/comments would be greatly appreciated.