oldmule
Active member
I'm still learning to use my new plasma cutter, so I have been a bit timid to break it out and play. I know, I'm being a bit paranoid....
I'm concerned about the gases coming off the cutting when I'm in the shop and I don't have a good ventilation system. What are you guys using?
I'm working out of an over sized two car garage. I have a furnace blower that I want to use for helping airflow, but, can't seem to figure out if I should be pushing air in from the top or pulling it out from the top. Where are the gases wanting to collect more?
Up to now, I have always used it out side. Tonight it is about 10* out and I have the furnace cranked up in the shop. I ran it for about 15 minutes total and had to open the garage a couple of times to try and get everything out.....
I know this crap isn't healthy to breath and I know I'm not getting good enough ventilation with just the door up a some.
Thanks
I'm concerned about the gases coming off the cutting when I'm in the shop and I don't have a good ventilation system. What are you guys using?
I'm working out of an over sized two car garage. I have a furnace blower that I want to use for helping airflow, but, can't seem to figure out if I should be pushing air in from the top or pulling it out from the top. Where are the gases wanting to collect more?
Up to now, I have always used it out side. Tonight it is about 10* out and I have the furnace cranked up in the shop. I ran it for about 15 minutes total and had to open the garage a couple of times to try and get everything out.....
I know this crap isn't healthy to breath and I know I'm not getting good enough ventilation with just the door up a some.
Thanks