So this guy bought a crate full of parts and started this project a number of years back, but I guess life got in the way, so he threw in the towel and now it sits in my shop. It's got a zz4 crate motor with a Tremec 5 speed using a Mcloud bell housing, clutch with hydraulic release bearing and a 9 inch Ford. He installed an aftermarket mustang 2 front suspension with GM Disc, Also an ididit steering column and wildwood brake and clutch masters. Last a set of Sanderson block huggers. As we all know it's tough to make a lot of dough on a deal like this. Plus I'm running low on passion since it's not mine and pickups are not really my taste. So I figured I'd post the build here to help me in the inspiration department. I've already bolted up the flywheel and clutch assy. to find that the hydraulic t/o bearing is too tall. So while I'm waiting on the owner to work that out with Mcloud, I'll bush and mount the pedal bracket assy. Then I'll tighten up the rear u bolts so I can get a base line on the rear pinion angle. Then I'll know where we need to go with the spring pads for proper drive line angle as well as do the math for drive shaft length. I've yet to check the rear end ratio, but being that zz4 is of the roller variety, this thing aughta scoot when it's done! [dr
