PorkChopMFMC
Well-known member
I have a 54 chevy car that has the 235 engine that slung a rod. I have a 74 250 engine and would like to know if they make mounts for that swap. Thanks for any help
Chevy 6 cylinder engine mounts
- Thread starter PorkChopMFMC
- Start date
Help Support Rat Rods Rule:
agdeuce
Well-known member
Some help
I believe the early 235 vehicles with the closed drive line have a different bell housing bolt pattern. Later Steve
I believe the early 235 vehicles with the closed drive line have a different bell housing bolt pattern. Later Steve
PorkChopMFMC
Well-known member
They do. I have another transmission
agdeuce
Well-known member
Motor mounts
There is a few companies that might be able to help. One is Stovebolt, Chassis engineering and the other is Buffalo Enterprises. I don't have the information to access these companies on the web
but you should be able to search. Good luck! Steve
There is a few companies that might be able to help. One is Stovebolt, Chassis engineering and the other is Buffalo Enterprises. I don't have the information to access these companies on the web
but you should be able to search. Good luck! Steve
klink
Well-known member
There are a lot of sources, but years ago when we did a 250 swap in a 53 Chevy, we used Butches Rod Shop. It's now Butches Cool Stuff http://www.butchscoolstuff.com/store/cart.php?m=product_list&c=39 the kit is for a small block but there's not much difference and since his kits are bolt in you can locate the mounts where they need to be.
