My Dodge Bros coupe!

[Burgerman]

Like everything about it. Seat frame looks cool. [cl

 

[Tripper]

As always, nice job Tripp.... [cl [P

Thanks Sarge!

Lookin' good Tripper, really like the seat...are you having it upholstered or are you going to cover it yourself ?[P[P

Still can't decide but gonna get an estimate to have it done... that will be the deciding factor! My buddy has a really good & cheap guy he uses so we'll see!

Like everything about it. Seat frame looks cool. [cl

Thanks... can't wait to be in the driver's seat!!!

BoB

 

[Tripper]

Just about have my steering sorted out. Since early cars were tight on foot space especially after a lil channeling... the ol Tripper's got a trick to get some extra space back for my clodhoppers! More on that next week!

BoB

 

[Torchie]

[P . [P
[P . [P
Torchie

 

[Skip]

Just about have my steering sorted out. Since early cars were tight on foot space especially after a lil channeling... the ol Tripper's got a trick to get some extra space back for my clodhoppers! More on that next week!

BoB

I'll be in line for that information.

 

[von-zipper]

Since early cars were tight on foot space especially after a lil channeling... the ol Tripper's got a trick to get some extra space back for my clodhoppers! More on that next week!

I'm in too! [S

Zipper

 

[Tripper]

Here's how I gained a lil extra space for my feets! Ididit has a column you can cut to the size you need and then install a bearing at that point! I didn't cut the 3/4" DD shaft but put it through another bearing on the floor to the u-joint... then on to the steering box. I saved 3/4" or so on both sides... doesn't sound like much but it was just enough! I cleco'd that panel down & will weld it in tonight or tomorrow! Column is set at 35 degrees!

BoB

 

[BillM]

Well that's slick! Looks really good.

 

[Torchie]

[cl
Every little bit helps.
[P [P [P
Torchie

 

[forbigpicture]

 

[Dr Crankenstein]

I saved 3/4" or so on both sides... doesn't sound like much but it was just enough!

Tall driver, small car... big V8, small car... every inch makes a difference! [cl

.

 

[Tripper]

This is what's up next!

BoB

 

[Torchie]

[P [P [P
Torchie

 

[smallfoot]

Wow, that's a nice piece! Where'd ya find that one?

 

[Old Iron]

Wow, that's a nice piece! Where'd ya find that one?

Yes it is
[P[cl[P

 

[Tripper]

Wow, that's a nice piece! Where'd ya find that one?

Yes it is
[P[cl[P

Thanks guys! I saw it at Joe's Speed Shop where I found my 4 port fuel block for $160 but found another one on daBay for $94!

BoB

 

[bob w]

Nice gauge panel. You're making great progress.

 

[Torchie]

As said. Nice gauge panel. I have sold a few gauge panels to hot rodders from old boats I have scrapped. Usually SW panels that are machine turned.
[P [P
Torchie

 

[Bamamav]

Purty!

 

[Tripper]

Got da gauges in... next I'll wire them up & on to the next item... ever closer!

BoB