My missguided metal work (the side work)

[animal]

Mike, those railings rock! Very nice work, my friend. [cl

 

[GJunktionMike]

Thanks Larry, I try.

One of those econo rust repairs. The guy didn't want fancy, just wanted to be able to drive around.

 

[1952B3b23]

Lookin good. That was almost a Fred Flinstone mobile with all them holes in the floor.

-Chris

 

[Torch]

I like the fact that it's a wagon and its got a stick shift

 

[GJunktionMike]

Torch it was a three on the tree but got changed to a floor.

another hand rail.

 

[GJunktionMike]

Another fine mess

One more of those I wish I had a before picture.

Doing a wheel well patch, knew there was bondo on the back but how bad could it be? Cut the wheel well out and the bondo was up in my patch, in a 6" wide bondo patch the center was v'ed in a 1/4". No problem clean out the bondo back aways hammer out the crease and move on, right.

 

[maverickmk]

Holy crap! Look how thick that bondo is

 

[bob w]

Bondo is too expensive to waste that way.

 

[GJunktionMike]

I would say without a doubt a gallon minimum on the back corner top to bottom. most of it was 1" thick. And 30+ holes for a puller, looks like just a couple where used by a slide hammer.

 

[Dirtyrat]

That makes me want to cry, even blind you should be able to straighten a panel closer than 1"....

 

[1952B3b23]

Wow thats a rediculous amount of bondo! I thought my truck was bad when i found at least a 1/2" worth covering a huge dent on the rear cab corner.

-Chris

 

[GJunktionMike]

hammer time [

 

[bob w]

Nice, Mike.

 

[Torchie]

Who says thick bondo will crack.[ddd
All the holes were to hold the bondo to the panel.
Very nice job on that truck box Mike.
Torchie.

 

[GJunktionMike]

One more out the door

Thanks guys it was a PITA. Looked like shootgun Sally had her way on that box.

 

[GJunktionMike]

Some odd ball work

Todays project, Sump cover.

 

[GJunktionMike]

Some ratrod seats.

 

[1952B3b23]

Cool, what'd you going to use those in?

-Chris

 

[GJunktionMike]

They are for the 32 Chevy sedan I work on last year (32 chevy sedan, building the ratcage)

 

[GJunktionMike]

Work on some thin tin.