The Low Buck Bagged Binder!

[canterburyfour]

Pedals are done

 

[Cyanide Jello]

Are you using the s10 gas tank xmember? And do you know if its the raised xmember or not?

 

[canterburyfour]

Are you using the s10 gas tank xmember? And do you know if its the raised xmember or not?

I'm using the raised cross member. You can see it in this picture.

 

[Cyanide Jello]

I need one for my truck when I bag it and didn't know if you were gonna toss it so I figured I'd ask...

 

[canterburyfour]

I need one for my truck when I bag it and didn't know if you were gonna toss it so I figured I'd ask...

I'm going to use it. Check out www.s10forum.com

 

[Cyanide Jello]

I'm going to use it. Check out www.s10forum.com

Err negative... I hate that site... I'm a member of S10forumS.com

 

[canterburyfour]

Gusseted the rear frame,

Steering column firewall bearing mount inside,

outside,

 

[canterburyfour]

Originally the backside of the front fenders was an inch of the ground,

now I have about 6"

Steering wheel installed,

 

[wrecker55]

looking NICE...gonna be a bad ride

 

[Andrew]

Awesome!
RHD oldies look so rad

 

[Gastrick]

Lookin good CB4.

 

[Bandit Ls-1]

badness!

 

[LordMaximo]

Getting there with good time frame.

 

[canterburyfour]

Thanks everyone!

Stripped the paint off of the cab. Between Jasco and 3M C.R.U.D. pads on the angle grinder it work well.

Shortened the bed 10" and cut the floor out.

Hanging the fenders off the back of the bed and I'll build a roll pan to go between them for the tail lights, exhaust and licence plate mount.

 

[canterburyfour]

 

[bob w]

I like the look of the rear fenders extending beyond the bed. All you work looks real good though. Gonna be a nice truck.

 

[Boltbreaker]

I like all the extra touches you are doing to change the look of the body.
Very cool.
I will be following this one for sure.

 

[canterburyfour]

The wife stripping

the tailgate. Spent a couple of hours straightening it out then removed most of the paint.



Got the rear fenders ready to mount and rear tires today.

 

[canterburyfour]

Got my air tank today for my air bag set up. Not sure what it is out of
but it's about 5 gallons and was hooked to a compressor as an
air storage tank.

It only has 2 ports so I was going to run a copper or
stainless line to one of these vintage fuel logs so I would have a few more.

or

This will all be mounted in the bed and I'll have a vintage looking set up

 

[sgo70]

Looking good, I like the rear end. I keep trying to get my wife to help but no luck yet.

Sean