Recent content by STEVE1103

Hood springs Don't have any to measure, but will need the hinge part too. Guess the best way to get them is get new ones!

Looking for support bar and hood springs for a 55 Ford F 100 :)

55 f100 Skip, it only gets worse if you let it!! I am 100% disabled Vet, but I still try to work on my cars and truck, not the darn new ones!!

:cool:Going to put my 327 in my 55 F 100, can't find a 300 Ford 6, will need a transmission, do have 2 power gulides and a 350, think the 200 R or 700 R would be better. Have put a duel master in, and a Mustang gas tank, been slow going, at 70 its hard to get going.

What is the best way to put fenders on a 55 F 100 without a bed? Was thinking something like motorcycle fenders. Don't think I can register the truck in PA without fenders.:rolleyes: Thanks STEVE

Looking for a good running Ford 300 6, or FE engine, with automatic transmission and drive shaft.:cool: Have a 50 Plymouth rat rod, runs for trade. In PA

1964 I H tractor, 2606, 6 cylinder, 5 speed, runs, rear live PTO hyd front and rear, blade for rear and rack, snow plow for front, has cab, books. Lakeville PA 18438, $6800 or trades, small old convert cars, 70 to 77 Monte Carlo :D

coupe50 Always liked those coupes, my Grand Pop always had them, he was a carpenter, he liked Desoto's, and when he had an fender bender my Uncle would make a stock car out of it, he had quite a few as I remember, sure wish I had got my hands on one!

Tank Gas tank is in, just need a neck and cap.

55 f 100 Hi, John L. I am useing the original drum brakes in mine, they seem to work but will see when I get it on the road. The Mustang tank is 16 gallons, I sure don't like the behind the seat tank. I had a 53, with a 303 Olds and Hydo back in 66, when I was stationed in NM, smelled gas all...

Started on my 55, duel master cylinder is in and working, still working on the wiring harness, installed a Mustang gas tank yesterday, tryed getting it between the frame rails but had to put it under with hand made hangers, should work OK.

Was told the 300 uses the same motor mounts as a 390-428 FE engine, had a 428 in my 55 F100, thats long gone, will the 300 go in with the mount that is there? The mount is tubular goes from side to side on the frame.

Have a VW engine cradle for a trike build. $400 Lakeville PA 18438

327 Talked to the guy I got the 327 from, told me it might need to be rebuilt, so I had this 400 that was rebuilt and decided to use it, would like the 327, for my reasons, am 64 my 65 Chevelle 350 HP, 327, I will never forget, strong 327, even with 90 thousand on it. Us old guys remember!!! Am...

400 Chevy I am installing has round exhaust ports, the exhaust manifolds in the car have square ports, will they work or do I need new manifolds?