Well here is a little update on the truck, I did buy two more wheels for the rear off of Ebay, when you look at something and say I am going to do a couple of things and just drive it well that is not as easy said as done. I said I was going to remove the headers,tune it up and drive well that has went out the window in a hurry, got the headers off and tried to put the manifolds on and the steering rod hits,fuel pump needed replaced so while replacing that I reached up and touched the fan and the water pump is worn out from the fan having the ends cut off to clear the lower radiator hose. So while the steering rod is a problem I decided to cut the steering column off 3" to give more room inside the cab exstend one of the steering rods so it would clear the manifold,put new fuel pump on made new pipe for lower radiator hose hook up,change pulley's for more fan clearance go to Advance Auto Parts but new fan,new points,new rotory button,new dist. cap,new wires,new plugs,new throttle cable also having carb rebuilt,the truck did not have turn signals so bought turn signal switch installed,welded up some cracks in rear fender,waiting on carb. and going to install new wiring harness. Just maybe once the carb returns and new wirng harness gets installed I will get to ride again. The truck appears to have been built many years ago and what I was told by a frind the guy drove the truck alot, how with the way some of the things were done to the truck I do not know. One thing is the throttle lingage was a close line wire tied on with tie raps to the carb and to the gas pedal just some unsafe things I had to change.